Instructions for Use of a Hydraulic Booster Pump

Jun 24,2024

I. Product Overview

The air-driven hydraulic booster pump is a fluid boosting device that combines high efficiency, energy saving, and environmental protection. It uses compressed air as a power source to drive the internal piston reciprocating motion, thereby converting low-pressure fluid into high-pressure fluid output. This product is widely used in petroleum, chemical, metallurgical, power, pharmaceutical and other industries, providing stable and reliable power support for various fluid transportation.

II. Product Features

Compact structure, small footprint, easy installation and maintenance.
High output pressure, stable flow rate, can meet the needs of various operating conditions.
Made of high-quality materials, wear-resistant and corrosion-resistant, long service life.
Equipped with safety protection devices to ensure safe use.

III. Preparation before Use

Check whether the air-driven hydraulic booster pump and its accessories are intact, and whether the connecting pipes are firm.
Confirm whether the air source pressure meets the equipment requirements, and whether the air source pipeline is unobstructed.
Check whether the power wiring is correct to ensure that the equipment can start normally.

IV. Operation Steps

Open the air source valve and adjust the air source pressure to the required range of the equipment.
Press the start button to start the air-driven hydraulic booster pump.
Observe the running status of the equipment and ensure that there are no abnormal noises, vibrations, etc.
Adjust the output pressure to the required value, which can be achieved by adjusting the air source pressure or the pressure regulating valve inside the equipment.
Monitor the equipment's output flow rate to ensure that it meets the usage requirements.
After use, close the air source valve, cut off the power, and clean and maintain the equipment.

V. Precautions

It is strictly forbidden to operate the air-driven hydraulic booster pump without water to avoid damaging the equipment.
During use, the equipment's operating status should be checked regularly, and any abnormalities should be dealt with promptly.
It is forbidden to disassemble or modify the equipment privately to avoid affecting the equipment's performance and safety.
The air source pipeline should be cleaned regularly to ensure that there is no blockage of impurities.
The equipment should be stored in a dry, ventilated environment free of corrosive gases.

VI. Maintenance and保养

Regularly clean the equipment to keep the equipment surface clean.
Regularly check whether all parts of the equipment are tightened, and tighten them if they are loose.
Regularly check whether the lubricating oil inside the equipment is sufficient, and add it if it is insufficient.
Regularly maintain the equipment, replace wearing parts, and ensure the stable performance of the equipment.

VII. Troubleshooting

If the equipment fails to start, the pressure is insufficient, or the flow rate is unstable, the air source pressure and pipeline should be checked first.
If the air source pressure and pipeline are normal, check whether the internal parts of the equipment are damaged or loose. If there is damage, replace or tighten them in time.
If the above methods fail to solve the problem, please contact a professional repairman for processing.

Through this instruction manual, we believe that you have a comprehensive understanding of the air-driven hydraulic booster pump. During use, please be sure to follow the operating procedures to ensure the safe and stable operation of the equipment. If you have any questions or need help, please feel free to contact our customer service staff.